Specification Sheet
Bocina coaxial ART de 2.35" (cono de aluminio)
SV-058C-44-025-0175-01
170–20kHzFrequency Range
80dBSensitivity
4ΩImpedance
15WRated Power
FeaturesWoofer con cono de aluminio de 2.35 pulgadas · Diafragma de domo de seda de 1 pulgada · Circuito magnético interno de NdFeB · Altavoz coaxial con tecnología patentada Sovox ISP
01General Specification
| Unit | LF | HF | |
|---|---|---|---|
| Diámetro | mm | ∅60.5 | ∅25.9 |
| Impedancia nominal | Ω | 4 | 4 |
| Potencia de programa [1] | W | 20 | 10 |
| Potencia nominal AES [2] | W | 15 | 5 |
| Sensibilidad [3] | dB | 80 | 83 |
| Rango de frecuencia | Hz | F0–20k | |
| Diámetro de la bobina móvil | pulgadas | 26.62 | 25.3 |
| Material del chasis | — | Chasis de hierro | |
| Material del imán | — | NdFeB | |
| Frecuencia de corte recomendada [4] | Hz | 2k | |
| Xmax [5] | mm | 1.3 | — |
| Volumen desplazado por el altavoz | L | 0.04 | — |
03Shipping Information
| Peso neto | kg | 0.11 |
| Tamaño de la unidad | mm | ∅60.5×H40 |
| Peso del multipack | kg | — |
02LF T/S Parameters [6]
| Resistencia DC | Re (Ω) | 3.2 |
| Frecuencia de resonancia | Fs (Hz) | 174 |
| Masa móvil | Mms (g) | 2.3 |
| Compliancia | Cms (mm/N) | 0.36 |
| Pérdidas mecánicas | Rms (kg/s) | 0.78 |
| Factor de fuerza | BL (N/A) | 2.77 |
| Factor Q mecánico | Qms | 3.22 |
| Factor Q eléctrico | Qes | 1.05 |
| Factor Q total | Qts | 0.8 |
| Volumen de aire equivalente | Vas (L) | 0.1685 |
| Inductancia de la bobina móvil | Le (mH) | 0.091 |
| Área del diafragma | Sd (cm²) | 18.1 |
| Eficiencia de referencia | η0 (%) | 0.08 |
04SPL & Impedance Curve
05Dimensions mm
Test Notes
- Program power is defined as 3 dB greater than AES power.
- Tested in free air for two hours using a continuous band-limited pink noise signal as per AES 2-1984 Rev. 2003.
- Measured on axis at 2 V, 1 m; SPL is the average at 200, 500, 800 and 1000 Hz.
- High-pass filter with slope 12 dB/oct. or higher.
- Xmax = (Hvc − Hg) / 2, where Hvc is voice-coil height and Hg the gap height.
- Thiele-Small parameters measured after preconditioning (20–22 °C, 50% RH, 2 h) by Klippel LSI. All specifications subject to change without notice.