Specification Sheet
Bocina coaxial ART de 8" con motor de compresión de 44mm
SV-200C-66-135-0060-01
70–20kHzFrequency Range
93dBSensitivity
6ΩImpedance
200WRated Power
FeaturesWoofer con cono de fibra de lana de 8 pulgadas · Tweeter de 3 pulgadas · Circuito magnético externo de ferrita · Estructura coaxial con bocina trasera
01General Specification
| Unit | LF | HF | |
|---|---|---|---|
| Diámetro | mm | ∅209.5 | ∅115 |
| Impedancia nominal | Ω | 6 | 6 |
| Potencia de programa [1] | W | 200 | 50 |
| Potencia nominal AES [2] | W | 100 | 30 |
| Sensibilidad [3] | dB | 93 | 101 |
| Rango de frecuencia | Hz | F0–20k | |
| Diámetro de la bobina móvil | pulgadas | 2 | 1.75 |
| Material del chasis | — | Chasis de hierro | |
| Material del imán | — | Ferrita | |
| Frecuencia de corte recomendada [4] | Hz | 1k | |
| Xmax [5] | mm | 3.5 | — |
| Volumen desplazado por el altavoz | L | 2.23 | — |
03Shipping Information
| Peso neto | kg | 4.55 |
| Tamaño de la unidad | mm | ∅209×H150 |
| Peso del multipack | kg | — |
02LF T/S Parameters [6]
| Resistencia DC | Re (Ω) | 2.3 |
| Frecuencia de resonancia | Fs (Hz) | 69.9 |
| Masa móvil | Mms (g) | 19.8 |
| Compliancia | Cms (mm/N) | 0.26 |
| Pérdidas mecánicas | Rms (kg/s) | 0.75 |
| Factor de fuerza | BL (N/A) | 9.6 |
| Factor Q mecánico | Qms | 11.4 |
| Factor Q eléctrico | Qes | 0.5 |
| Factor Q total | Qts | 0.47 |
| Volumen de aire equivalente | Vas (L) | 20.1169 |
| Inductancia de la bobina móvil | Le (mH) | 0.5 |
| Área del diafragma | Sd (cm²) | 232.35 |
| Eficiencia de referencia | η0 (%) | 1.3 |
04SPL & Impedance Curve
05Dimensions mm
Test Notes
- Program power is defined as 3 dB greater than AES power.
- Tested in free air for two hours using a continuous band-limited pink noise signal as per AES 2-1984 Rev. 2003.
- Measured on axis at 2 V, 1 m; SPL is the average at 200, 500, 800 and 1000 Hz.
- High-pass filter with slope 12 dB/oct. or higher.
- Xmax = (Hvc − Hg) / 2, where Hvc is voice-coil height and Hg the gap height.
- Thiele-Small parameters measured after preconditioning (20–22 °C, 50% RH, 2 h) by Klippel LSI. All specifications subject to change without notice.