Người bán:SOVOX

MiniMax3 Monitor

8.480.000₫

  • Loa để bàn đồng trục 3 đường tiếng nhỏ gọn nhất
  • Thùng loa nhôm nguyên khối bề rộng 108 mm
  • Kiến trúc đồng trục ISP™ được cấp bằng sáng chế
  • Thiết kế 3 đường tiếng với màng cộng hưởng thụ động
  • Dải trầm kiểm soát chặt chẽ xuống tới 46 Hz
  • Ngõ vào XLR cân bằng và RCA
Color
Color: Dòng AP
Cấu hình

Your purchase, fully supported

Free ShippingComplimentary tracked delivery.
Up to 4-Year WarrantyStandard warranty included; extend it free of charge by registering your product. 30-Day ReturnsStart an eligible return within 30 days. Audio System ExpertsGuidance for pairing, placement and setup.

Pairs well with
MiniMax3 Monitor
8.480.000₫
MiniMax3 Monitor in silver on its desk stand, lit against a dark horizon

Công nghệ

Yes, that’s a
three-way coaxial.

A true three-way coaxial, in a cabinet 108 mm wide.

240 Hz / 3.6 kHz

Crossover points

46 Hz

Bass extension, −6 dBBass, −6 dB

Two-way vs. three-way

The vocal no longer rides on the kick.

A compact two-way plays the kick and the vocal through one small woofer. MiniMax3 gives the voice its own 3″ midrange, so each part of the mix stays distinct.

2-WAY

Typical compact

Bass and voice share one cone.

Tweeter · Above ~2.5 kHz

Highs

Woofer · Below ~2.5 kHz

Kick, bass and voice

3-WAY

MiniMax3

Every layer gets its own driver.

High · Above 3.6 kHz

Cymbals, air, detail

1″ silk-dome tweeter · 20 W

Mid · 240 Hz – 3.6 kHz

Vocals, guitars, keys

3″ carbon-fiber midrange · 20 W

Low · Below 240 Hz

Kick and bass

3.5″ carbon woofer + 5″ passive radiator · 40 W

  • High · 1″ silk-dome tweeter · 20 W
  • Mid · 3″ carbon-fiber midrange · 20 W
  • Low · 3.5″ carbon woofer + 5″ passive radiator · 40 W

One amplifier per way · Third-order crossoversTwo-way shown for illustration; crossover points vary by model.

Patented ISP™ coaxial

Set the presence. Sit back. It’s gone.
Stop mixing with your head in a vise.

With separate drivers, the 3.6 kHz region shifts every time you move, right where vocal presence lives. ISP puts both drivers at one point, so it stays put.

The MiniMax3 Monitor coaxial driver: a 1″ silk-dome tweeter at the center of a 3″ carbon-fiber midrange

Separate drivers

Lean in, and the presence region drifts.

At your ear Combined

ISP coaxial

Lean in or sit back. It holds.

At your ear Combined

Illustration of the crossover region, exaggerated for clarity.

3.5″ carbon woofer

Kick and bass shouldn’t blur together.
Not even on a 3.5″ woofer.

Keeping the kick and the bass apart takes control, not just depth. So the low end gets its own dedicated 3.5″ woofer that never plays the vocal, built part by part for one job: the magnet, the motor and the coil, plus a passive radiator.

HLMS™

High-linearity motor

46 Hz

Bass extension, −6 dB

No port

Passive radiator

The 3.35-inch (85 mm) magnet of the MiniMax3 woofer

01 · 3.35″ magnet on a 3.5″ woofer

The kick ends when the track says so.

A denser field in the gap gives the voice coil a firmer grip. It starts the cone on the hit and brakes it on the release, so the tail you hear is the tail you mixed.

MAGNET SIZE · KICK RESPONSESmall magnetfield in the gap3.35″ magnetfield in the gap

Why size matters — more field in the gap, a tighter kick

Panels are illustrations of the effect, not measurements.

Cutaway of the MiniMax3 woofer motor with the copper Faraday ring and the demodulation ring

02 · SOVOX HLMS™ · two rings in the gap

Louder doesn’t mean dirtier.

Turn a small woofer up and two things go wrong: it adds harmonics you never put in the mix, and it starts squashing the peaks. SOVOX HLMS™ tackles both in the gap: a copper Faraday ring keeps the push even, and a demodulation ring keeps the field steady under current.

PUSH ACROSS THE STROKEMiniMax3Typicalcoil in the gapPush← strokereststroke →

Why it works — the push stays even from one end of the stroke to the other

ANALYZERMiniMax3TypicalLevel60 HzH2H3H4H5

Harmonics stay low as you push the level

COMPRESSIONMiniMax3Typical Input →Out GRTyp.MM3

Peaks come through at high level, not squashed

Panels are illustrations of the effect, not measurements.

The six-layer voice coil of the MiniMax3 woofer

03 · Six-layer voice coil

The last mix of the night sounds like the first.

As a voice coil heats up, it quietly loses level, and you start pushing the fader to make up for it. A custom six-layer coil puts more copper in the gap to take that heat, so the woofer stays where you set it.

OUTPUT OVER A LONG, LOUD SESSIONMiniMax3Typical0 dB−1−2−3015304560 min

Output at a constant high level, over an hour

Panels are illustrations of the effect, not measurements.

The 3.5 × 6.3-inch passive radiator of the MiniMax3

04 · 3.5″ × 6.3″ passive radiator

Nothing chuffs on the drop.

On a ported speaker, part of the low end you hear is the port itself: air noise on loud notes, and a tone from the tube. MiniMax3 has no port. A 3.5″ × 6.3″ passive radiator takes the bass down to 46 Hz (−6 dB), so what you hear is the woofer, not the tube.

ANALYZER · LOUD BASS NOTEMiniMax3Typical port noise pipe resonance20501002005001k2k Hz

A loud bass note on an analyzer: ported vs. no port

Panels are illustrations of the effect, not measurements.

DSP room adaptation

Your desk is part of the speaker.
Tell MiniMax3 where it sits.

A desk under a speaker, or a wall behind it, adds bass that isn’t in your mix. Choose Free, Desk, Wall or Desk & Wall, and the DSP evens that boost back out. Then trim treble and bass to match your room, not to flatter it.

The volume and function knob on the MiniMax3 Monitor rear panel
With the presetWithout correction+6 dB0-6-1220501002005001k HzOn stands, away from wallsSitting on the desktopBacked up to a wallBoth at once

Pick the placement that matches your setup. The DSP evens out the bass the room adds.

Placement

FreeDeskWallDesk & Wall

Treble

+2 dB0−2 dB

Bass

−4 dB−2 dB0Dynamic

Set from the knob on the rear panel.

Measured on Klippel NFS (see Specs). Dashed curves mirror each preset’s correction; real rooms vary.

Specifications

Don’t take our word for it.
Take the measurements.

Every figure lists its test condition, so you can line it up against any review or datasheet.

46 Hz – 20 kHz

Frequency response, −6 dB

97 dB

Max SPL, short-term @ 1 m

240 Hz / 3.6 kHz

Crossovers, 3rd order

< 1 %

THD, 240 Hz – 20 kHz @ 80 dB

80 W

Class-D, per speaker

4.1 kg

192 × 108 × 199 mm

01Measurements

9 charts

Response

In-room

Distortion

Directivity

Measurement: On-axis response Acoustic axis SPL

On-axis responseAcoustic axis SPL

Klippel NFS · 1 m, free field

Flat across the audible band — you hear the mix, not the speaker.

Full specifications

Frequency response49 Hz – 20 kHz−3 dB
Frequency response46 Hz – 20 kHz−6 dB
Max SPL @ 1 m97 dBShort-term · 100 Hz – 6 kHz
Max SPL @ 1 m95 dBLong-term · IEC 60268-5
Crossover240 Hz / 3.6 kHz3rd order
THD @ 80 dB / 1 m< 1 %240 Hz – 20 kHz
THD @ 80 dB / 1 m< 2 %100 – 240 Hz
Signal-to-noise ratio105 dB

07Finishes & in the box

Black or Silver · stand included

Two MiniMax3 Monitors on their isolation stands with the cable box and manual

Pair shown for illustration. Quantity follows your order.

Two magnetic speaker grilles, one face up and one face down

Magnetic grilles, front and back.

In the box · per speaker

  • Powered speaker× 1
  • Isolation stand× 1
  • Magnetic grille× 1
  • Power cable× 1
  • Balanced XLR cable× 1
  • Tools and manual

Finishes

BlackSilver

Specifications subject to change. Full test conditions in the manual.

Frequently asked questions

What warranty does the MiniMax3 Monitor come with?
The MINIMAX series includes a 1-year standard warranty covering material and workmanship defects under normal use, plus an optional +3-year extended warranty available through product registration. Register the product with a valid proof of purchase; the extended period is added after the standard warranty expires. For a claim, contact customerservice@sovox.com with your serial number and proof of purchase.

Can I return the MiniMax3 Monitor if it does not work on my desk?
You can return your SOVOX product within 30 days of receiving it for a full refund, provided it was purchased from the SOVOX Official Store or an authorized dealer and is returned in its original packaging in new or near-new condition. Email customerservice@sovox.com to request an RMA number; once issued, the product must reach us within 14 calendar days. Shipping cost and transit risk for returns are borne by the customer.

Where does the MiniMax3 Monitor ship from, and who handles support?
Ships from within the U.S. Support, RMA numbers and warranty claims are handled directly by SOVOX at customerservice@sovox.com — there is no third-party distributor in between.

How is a 3-way coaxial speaker different from a 2-way speaker of the same size?
A 2-way speaker crosses over from woofer to tweeter around 2-3 kHz, in the region where the ear is most sensitive to timing and directivity errors. The MiniMax3 Monitor crosses at 240 Hz and 3.6 kHz, so a dedicated 3″ carbon fibre midrange covers the vocal band without also moving air for the low end. Mounting the 1″ silk dome tweeter on the same axis as that midrange makes the pair behave closer to a single point source, which keeps the response consistent as you move vertically at a desk.

How much desk width does the MiniMax3 Monitor need?
Each speaker is 108 mm wide, 192 mm high and 199 mm deep, so a stereo pair occupies 216 mm of total width before any gap to a display or wall. Net weight is 4.1 kg per speaker, which keeps it within the range of most desk clamps and monitor arms.

Do I need an audio interface to use the MiniMax3 Monitor?
No. It accepts balanced XLR at +4 dBu and unbalanced RCA at −10 dBV, so it connects directly to an audio interface, a mixer, or a consumer source with RCA outputs. The rear USB-C port is for firmware updates only and is not an audio input.