4 ทาง · ไบแอมป์MC4105 — ระบบลำโพงหลักหลังจอสำหรับโรงภาพยนตร์
นโยบายการจัดส่ง · นโยบายทางกฎหมาย

MC4105

ระบบลำโพงหลักหลังจอสำหรับโรงภาพยนตร์

ระบบลำโพงหลักหลังจอแบบไบแอมป์

การตอบสนองความถี่3 ทาง · ไบแอมป์±3 dB @ 2π
มุมกระจายเสียงLF: 1200 W · MF/HF: 300 WH × V
ระบบ4 ทาง · ไบแอมป์LF: 99 dB · MF/HF: 105 dB SPL สูงสุดพิกัด @ 1 ม., 2π
น้ำหนักสุทธิ44.3 kg / 22 kgต่อโมดูล
เอกสารสเปก (PDF)
01

คุณลักษณะเด่น

  • Four-way, bi-amplified architecture with independent LF and mid/high-frequency amplifier channels
  • 15" LF x 2 low-frequency section in a bass-reflex enclosure
  • 10" coaxial MF + 2" HF + Ribbon UHF x 8 mid/high-frequency section
  • 38 Hz–20 kHz frequency response with 90° x 45° nominal coverage
  • LR-24 dB/oct @300 Hz (LF-MF/HF) active LF crossover; on top of the LF module
02

ภาพรวม

MC4105 คือระบบลำโพงหลักหลังจอ 4 ทางแบบไบแอมป์ระดับพรีเมียม สำหรับโรงภาพยนตร์ขนาดใหญ่พิเศษ

ให้การแยกรายละเอียดเสียงและความคมชัดระดับสูงสุดในทุกย่านความถี่

03

ข้อมูลจำเพาะ

ประเภทผลิตภัณฑ์ระบบลำโพงหลักหลังจอสำหรับโรงภาพยนตร์
ประเภทระบบ4 ทาง · ไบแอมป์
การตอบสนองความถี่ (±3 dB @ 2π)138 Hz–20 kHz
ช่วงความถี่ใช้งาน (-10 dB @ 2π)128 Hz–20 kHz
มุมกระจายเสียง (แนวนอน × แนวตั้ง)90° × 45°
M260(W)LF MODULEMC4105(T)MF / HF MODULE
การจัดวางดอกลำโพง15"LF × 210" coaxial MF + 2" HF + Ribbon UHF × 8
ความต้านทานระบุ4Ω8Ω
กำลังขับ AES 100 ชั่วโมง2800W270W
กำลังขับ AES 2 ชั่วโมง1000W337.5W
กำลังขับโปรแกรม31600W540W
ความไว (2π) @1 W/1 m102dB100dB
ระดับความดันเสียงสูงสุดระบุ /1 m @ 2π131dB124.3dB
ระดับความดันเสียงสูงสุดจากการคำนวณ /1 m @ 2π4137dB130.3dB
ความถี่ตัดข้ามครอสโอเวอร์LR-24dB oct @300 Hz (LF–MF HF)1.8 kHz พาสซีฟ (MF–HF) & 4.0 kHz พาสซีฟ (HF–UHF)
ฟิลเตอร์กรองความถี่สูงที่แนะนำ (HPF)25 Hz, LR24-
ประเภทตู้ลำโพงตู้เปิดแบบเบสรีเฟล็กซ์ตู้ปิด with coaxial driver and super-tweeter array
วัสดุตู้ลำโพง / พื้นผิวสัมผัสMDF · PVCMDF · ลามิเนต PVC
ขั้วต่ออินพุตขั้วต่อไบนดิงโพสต์ขั้วต่อไบนดิงโพสต์
ตัวเลือกการติดตั้งBehind-screen installationOn top of the LF module
ขนาด ก×ส×ล (mm)W701 × H961 × D450 mmW410 × H802 × D302 mm
น้ำหนักสุทธิ44.3 kg22 kg
04

การตอบสนองความถี่

MC4105 — ระบบลำโพงหลักหลังจอสำหรับโรงภาพยนตร์
M260(W)1 W / 1 ม., สนามเสียงอิสระ, การเกลี่ย 1/6 อ็อกเทฟ
05

มิติขนาด

MC4105 — ระบบลำโพงหลักหลังจอสำหรับโรงภาพยนตร์
มุมมองด้านหน้า
MC4105 — ระบบลำโพงหลักหลังจอสำหรับโรงภาพยนตร์
มุมมองด้านข้าง
MC4105 — ระบบลำโพงหลักหลังจอสำหรับโรงภาพยนตร์
มุมมองด้านบน
M260(W)W701 × H961 × D450 mm · 44.3 kg
MC4105(T)W410 × H802 × D302 mm · 22 kg
หมายเหตุเกี่ยวกับข้อมูลจำเพาะ
  1. 1Low-frequency response and sensitivity specifications are referenced to half-space (2π) conditions, representative of typical cinema baffle-wall installation. Frequency-response graphs are measured in an anechoic free-field (4π) environment unless otherwise noted. In the low-frequency region the same loudspeaker measures about 6 dB higher under 2π than under 4π (in practice 3–6 dB depending on frequency and baffle conditions); this is a difference of measurement convention, not of performance.
  2. 2Rating based on an IEC filtered random-noise test signal, band-limited 50 Hz–20 kHz, with a peak-to-average ratio of 6 dB
  3. 3Recommended amplifier output at the applicable impedance should not exceed the program power, giving an unclipped output waveform while avoiding loudspeaker damage; an amplifier capable of at least the RMS continuous power (AES 100 h) is recommended to realize full loudspeaker performance. The actual amplifier match should be determined by calculation for the listening distance (see note 1).
  4. 4Calculated maximum SPL is derived from the rated (continuous) power and half-space (2π) sensitivity and is a calculated, not measured, figure; at a 6 dB peak-to-average ratio it exceeds the rated value by 6 dB, representing short-term peak capability rather than a level the system can sustain.
  5. 5The frequency-response graphs on this page are measured on-axis at 1 W/1 m in an anechoic free-field (4π) environment with 1/6-octave smoothing; the frequency response and sensitivity in the specification table are stated under half-space (2π) conditions. Lower readings in the low-frequency region of the graph therefore reflect the difference in convention rather than a difference in performance. 2π-format curves are available on request.